stress distribution

Quantitative analysis for the stress distribution has proved the feasibility of micro-grid application in industrial furnace.

对微格栅砌体应力分布的定量分析表明:微格栅砌体完全能够满足工业炉炉体的力学性能要求.

互联网摘选

Stress distribution on the surface of alveolar bone is very complex, not simple compression or tension.

齿槽骨表面的应力分布非常复杂,同一部位三个主应力值相差很大,且多为反号, 不是简单的受拉或受压.

互联网摘选

The axial stress distribution after cooling is changed greatly under internal pressure.

介质压力对完全冷却后的轴向应力产生较大影响.

互联网摘选

Under the same loads, the improved swinging arm had a better stress distribution.

改进后在同样的载荷下, 摆臂的应力分布更加合理.

互联网摘选

Using method of three dimensional FEM analysis, whole stress distribution in the joints is are obtained.

用三维弹塑性有限元分析方法, 全面分析了点焊搭接接头的应力分布情况.

互联网摘选

The stress distribution of cable-girder anchorage zones under cable forces and U-prestressing tendon is analyzed.

分析了索力和U形钢束共同作用下主梁锚固区应力大小及分布情况.

互联网摘选

The width and depth of laser transformation hardening zone and residual stress distribution were measured experimentally.

实测了激光相变硬化区的宽度和深度及残余应力分布.

互联网摘选

A general solution for stress distribution around rectangle holes in anisotropic elastic plates is presented.

推导了各向异性平面弹性体中矩形孔洞边缘的应力分布公式并给出了数值计算结果.

互联网摘选

Objective : To study stress distribution in periodontal tissue of titled abutment before and after fixed restoration.

目的: 研究倾斜基牙固定修复前后牙周组织受力情况,为临床固定义齿设计提供理论依据.

互联网摘选

This paper chiefly describes the general character of stress distribution of the arch shaped arch-abdomen dam.

本文着重介绍拱形腹拱坝的坝体应力的一般规律.

互联网摘选

The stress distribution and amount of deformation has been counted under different pavage conditions.

计算不同情况下该种管道的应力分布及变形量.

互联网摘选

Results: The deviation and stress distribution of the edentulous jaws and the base plates were obtained.

结果: 得出了七种模型的基托及无牙颌骨的位移及应力分布值.

互联网摘选

We defined the conditions of the plane stress distribution of thin plates subjected to in-plane forces.

我们定义了承受平面力的薄板平面应力分布条件.

词典精选例句

Three-dimensional modal, stress distribution and harmonic response laws of water-lubricated bearings were studied using element software.

利用有限元软件研究了水润滑轴承的三维模态及其应力分布和谐响应规律.

互联网摘选

Throuth the stress calculation for the model slices the pipes D stress distribution state is solved.

通过对冻结模型的切片应力计算,求出了涵管在静土压力下的三维应力分布.

互联网摘选